I am so happy to have finally finished this project! I bought all the materials back home before I came back to school, and I finally got around to finishing it this afternoon! My original plan was to follow the exact directions from studs and pearls for the Lanyard Double Chain Bracelet (http://www.studs-and-pearls.com/2011/09/diy-lanyard-double-chain-bracelet.html), but sadly, I purchased the wrong kind of chain, so I tried, but my efforts failed. However, I might try to make it again, this time with the correct type of chain! Nevertheless, I like what I came up with, and it still has the same idea of the studs and pearls bracelet.
Here's what you'll need: 
- Enough chain to go around your wrist twice (I bought mine the length that you see above, and didn't cut it, so if you're going to cut yours... I have no tips on how to help you. Godspeed.)
- Jump rings (I bought a package of like, 100 & used 5)
- Lobster clasps (you'll only need one, but I bought a 4-pack for future use, it's cheaper that way)
- Leather cord (You can buy the huge spool if you'd like, but that's about $15, and mine was around $4, and I still have plenty left over)
- Needlenose pliers (I think people who aren't from East Texas know these as jewelry pliers. I didn't have any, so I improvised...with a wrench. It was painful.)
And Here's what you do! :
1. First, cut a piece of leather cord, about 55-60 inches. I cut mine 60 inches when I was attempting to make the first bracelet, and so I just kept it. But I cut off around 5-7 inches when I was done, so it was a little long.
2. Locate the center link of the chain. This can be easily done by folding the chain in half, matching the two ends up, & see which link is the middle. Thread the leather cord through the center link, making sure both tails of the cord are even.
3. Begin threading the leather cord through each link of the chain. Make sure you don't pull too tight or the chain will get all caddywompus, and we can't have that, now can we?? But seriously, make sure the chain stays somewhat flat, and be careful not to twist the leather.
4. Continue threading the leather through the chain until you reach the end of that half of the bracelet. This is what you should have:
6. Once you finish threading the cord, you'll need to tie off the leather. Before you cut it, bring the end of the cord back through the last link of chain, towards you. You should then have a loop of leather cord at the top of the link. Bring the end of the cord up through that loop, away from you. After you pull tight, you should have a small knot.Just cut the excess cord off and it should be sturdy! (I understand that these instructions are a little difficult to understand, but I have full confidence that if you've gotten this far, you must have some level of intelligence and will be able to figure something out. Use your problem-solving skills.)
7. On the center link (the one you tied the ribbon to), attach two jump rings. The easiest way to do this is to open just one, using the pliers. Or you can pry it open with your fingers like I did, but my broken fingernails and still-hurting fingers strongly urge against it. Next, slip the ring onto the center link, but don't close it yet! Take a second closed ring and slip it onto the open ring. Then, again using the pliers, squeeze the first ring closed, making sure it is closed tightly so it doesn't break.
8. Next, on the end with the two leather knots, attach a jump ring to both of the end links on each side, and then connect them to each other
9. Then, open a new jump ring and slip it onto one of the two jump rings attaching the loose ends. Place a lobster clasp on the open ring, and then close it with the pliers, making sure it's closed tightly!
No comments:
Post a Comment